How to maintain the lens glass panel?

Thousands of lens glass panel products have been entered, and each has its own characteristics, but most of them are electronic product lens glass panels. Lens glass panels have many advantages, but compared to maintenance, we hope to use them for a long time. Therefore, an important issue in the use of lens glass panels is how to maintain lens glass panels.Today we will introduce four methods for maintaining lens glass panels.

1: Avoid high temperature

The temperature of the lens glass panel should not be higher than 90 degrees during continuous use, because the thermal deformation of the ordinary lens glass panel is stable at about 100 degrees, and the temperature of the normal lens glass panel will be thermally deformed at 98 degrees, so acrylic acid should be avoided High temperature deformation of the product.

2: Avoid touching hard objects

When using the lens glass panel, the lens glass panel is actually an organic plastic.Although the ordinary hardness can be played on the hand, if it touches very hard cement, then we can add hard anti-scratch treatment to the lens glass panel , Can make its hardness reach 3H, if the lens glass panel touches harder such as nails and other needles, our ability at this time can only increase the hardness of the lens glass panel to 6H, so we try to make the lens glass panel principle these Sharp and hard objects touch and rub. The hardness of the lens glass panel surface is equivalent to the hardness of aluminum. Although the hardness is already very large, it is still easy to scratch.

3: Soft towel + 1% soapy water decontamination

If the lens glass panel is blurred or unclean due to slight scratches or dust absorption caused by static electricity, or there is a gray layer on the lens glass panel due to other reasons, we recommend using 1% soapy water to wipe it clean with a soft cloth. This wipe is not only clean, but it is not easy to get ash layer again. And it does not need to be rinsed with clean water again, it is convenient to clean and there will be no hand lines on the lens glass panel.

4: Focus on thermal expansion and contraction

When maintaining the lens glass panel, you will usually encounter characteristics.The lens glass panel will increase in length, width and height, but it will decrease in winter.The decrease and increase of the layer is very low, but there will be a thermal expansion and contraction The lens glass panel has a certain expansion coefficient, so the factory should consider the thermal expansion and cold shrinkage coefficients of the acrylic lens glass panel during the installation process, and there must be a tensile gap during the assembly process. This is a detail that needs attention during the assembly of the lens glass panel.